User's Manual

AirHarmony-4000 (Integrated Duplexers) Installation Guide
UGD-D01080 Airspan Commercial and Internal Use 37
3. Thread the 3 wire (stranded 16AWG) cable through the tail nut, gland seal, body and
rubber gasket of the connector casing as shown below. Do not tighten the tail nut.
Figure 28: power cable assembly
4. Insert the stripped wire ends of the cable into the connector sleeves.
Figure 29: Connector on cable
5. Secure the wire ends of the power cable into the head part of the connector, as shown
below.
Figure 30: Plug pins
Figure 31: Pin assignment
Pin #
Wire Color
Description
1
White
Neutral
2
Black
Phase
3
Green
Ground