User's Manual

AirHarmony-4000 (Integrated Duplexers) Installation Guide
UGD-D01080 Airspan Commercial and Internal Use 25
Figure 11: Mounting plate mounted
4.2.3 Mounting on a Wall
The following images show the wall mount assembly.
Caution: Take care to install the Pole/Wall mounting plate in the correct orientation.
Verify that the mounting pins are facing upwards as shown below.
1. Position mounting plate against the wall with mounting pins facing up. Be sure to
position the wall mounting plate straight with level mounting to ensure the unit sits
evenly.
2. Mark the wall through the holes on the wall mount at the required height.
3. Attach the mounting plate to the wall using Lag bolts (x8 recommended).
Note: Lag bolts (x8) and necessary hardware are not supplied by Airspan and are the
responsibility of the installer. Recommended minimum 5/16 x 4” dia. (8mm x 100mm)
with appropriate plugs according to field conditions.