User's Manual

AirHarmony-4000 (External Cavity Filters) Installation Guide
UGD-D01019 Airspan Commercial and Internal Use 44
Figure 38: AC Connector disassembled
2. Strip back and remove the outer sheath to expose the inner black, white and green
insulated wires to a length of 3 cm (1.18 in). Then strip back 6 mm (0.24 in) of the inner
core insulation.
Figure 39: Strip wire
3. Thread the 3 wire (stranded 16AWG) cable through the tail nut, gland seal, body and
rubber gasket of the connector casing as shown below. Do not tighten the tail nut.
Figure 40: power cable assembly
4. Insert the stripped wire ends of the cable into the connector sleeves.
Figure 41: Connector on cable