User's Manual

AirHarmony-4000 (External Cavity Filters) Installation Guide
UGD-D01019 Airspan Commercial and Internal Use 22
4 Installing AirHarmony-4000
Install the AirHarmony-4000 eNodeB by pole/wall mount. AirHarmony-4000 is mounted on a pole or
wall in close proximity to its external antenna (connectorized variant).
Caution: Proper local rigging and hoisting practices should be followed when installing
the AirHarmony-4000 on pole or wall.
4.1 External Filter Assembly
Note: The External Filters’ set should be assembled on the AirHarmony-4000 prior to
installing on the pole/wall mount. Airspan recommends doing the assembly on a steady
secure surface.
1. Remove the AirHarmony from its packaging in preparation for the External Filters’ set
assembly.
Figure 6: AIrHarmony-4000 with Sun Shield without external filters
2. Lie the AirHarmony-4000 down on a flat surface so as to facilitate assembly of the
external filters’ set (either Low, High or Full Band).