User's Manual

AirHarmony-1000D Installation Guide
UGD-D01083 Airspan Commercial and Internal Use 31
6 Cable Connections
Hazardous voltage! Before working, ensure that the power is removed from the power
connection cables. When the system is powered on, do not touch the power
terminals.
6.1 Copper Ethernet Cable Assembly
The following demonstrates the recommended assembly instructions, hardware and tool requirements
for the proper Ethernet cable assembly of the Ethernet Category 5e (enhanced) (CAT5e) cable used
by Airspan products.
The Ethernet cable is connected using a standard RJ45 connector protected by a harsh environment
protective casing.
6.1.1 Hardware Requirements
The following are the cable and connectors available from Airspan.
Table 13: Cable Hardware
Airspan Part Number
Description
CAT5e-STP-305M-R
CAT5e Ethernet Cable, 305M (1000ft), STP, Reel
RJ45-ETH-SHLD-CONN
RJ45 Ethernet Connector, Shielded
6.1.2 Assembly Instructions
The Copper Ethernet cable is connected to the AirHarmony-1000 using a Gland connector assembled
on the bottom panel of the unit.
1. Remove the Gland connector by unscrewing the body from the AirHarmony-1000, using
the (supplied) Gland wrench.
2. Pass the prepared Ethernet cable through the tail nut, gland seal, body and front seal of
the connector casing as shown below. Do not tighten the tail nut.
Figure 23: Ethernet Cable through connector