User's Manual
AirHarmony-1000D Installation Guide
UGD-D01083 Airspan Commercial and Internal Use 33
4. Verify that the locking latch on the cable connector is engaged on the board connector.
5. Slide the inner housing and ground shield (if present) over the cable and over the molding.
Figure 26: Slide on inner housing
Note: Check that there no space between the inner housing and mounting flange. Check
and remove any debris that might interfere with the connection.
6. Slide the outer shell over the inner housing and turn the outer bayonet shell 1/4 turn
clockwise, until it clicks into place.