User's Manual

AirHarmony-1000D Installation Guide
UGD-D01083 Airspan Commercial and Internal Use 23
5 Installing AirHarmony-1000D
Install the AirHarmony-1000D eNodeB by pole mount or wall mount. AirHarmony-1000D is mounted
on a pole or wall with its pre-installed antenna (front mount or SBA variants (pending)) or in close
proximity to its external antenna (connectorized variant). Take care to install the mounting plate the
correct way up. This is with the slot openings in the bracket at the top edges as shown below.
Caution: Proper local rigging and hoisting practices should be followed when installing the
AirHarmony-1000D.
5.1 Pole Mount Assembly
The following images show the pole mount assembly.
1. Prepare the mounting plate by assembling the pole clamps in the provided threaded holes
with the provided M8X20 Hex Cap screws.
Figure 9: Pole mounting assembly preparation
2. Insert the clamp straps through the slots in the mounting plate passing them through the pole
clamps.