User's Manual

CRM Module User Guide
Page 17 Commercial in Confidence UWB-D00658 Rev A
5 Connecting the CRM Mini PCIe Module
Note: Carefully remove the CRM Mini PCIe module from the packaging box
Caution: It is the responsibility of the person installing the CRM module to
ensure that only those antennas certified for use with the product are used.
The use of any antenna other than those certified with the product is
expressly forbidden.
Caution: The CRM module and the antennas must be installed only by
experienced installation professionals who are familiar with the local safety
codes and are licensed by the appropriate government authorities.
To connect the CRM Module:
1. Make sure the unit is turned off. Remove the cover from the unit.
2. Carefully slide the CRM Mini PCIe module into the mini PCI slot. Align the pins and push
evenly and slowly and ensure it is properly seated.
3. After the device has been connected, Windows will detect the module and you will be
prompted to install the software and drivers.
5.1 Typical CRM Installation
The following displays a typical installation with the CRM Mini PCIe module installed.
Figure 3 - Typical CRM in iPro installation