User's Manual

CRM Module User Guide
Page 10 Commercial in Confidence UWB-D00658 Rev A
FCC Notice
Federal Communication Commission Notice
The United States Federal Communication Commission (FCC) and the Canadian Department
of Communications have established certain rules governing the use of electronic equipment.
Part 15, Class B.
This device complies with Part 15 of FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Limitations
The CRM PCIe module is a terminal station intended for use in the Airspan outdoor CPE V70
and MRTe series.
Antenna Limitations – see Antenna Types
Labeling Requirement
Airspan CPE V70 and MRTe series label must include wording similar to the following:
 “Contains FCC ID:PIDCRM3650”