User's Manual

AU540 eNB B41 User Guide
UGD-D01112 Airspan Commercial and Internal Use 3
Warnings and Cautions
Human Exposure to Radio Frequencies
The AU540 eNB B41 antennas should be installed with a minimum distance of 20 CM from your body.
Radio Interference
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to internal vehicle radio
communications.
Please ensure a maximum separation between the AU540 eNB B41’s antenna and other antennas.
Modifications
Any changes and modifications to this device that are not expressly approved by Airspan Networks
may void the user's authority to operate the equipment.
General
 Only qualified personnel should be allowed to install, replace, and service the equipment.
 The device cannot be sold retail, to the general public or by mail order. It must be sold to
operators.
 Installation must be controlled.
 Installation must be performed by licensed professionals.
 Installation requires special training. The AU540 eNB B41 module and antenna should be
installed ONLY by experienced installation professionals who are familiar with local building
and safety codes and, wherever applicable, are licensed by the appropriate government
regulatory authorities. Failure to do so may void Airspan's product warranty and may expose
the end user or the service provider to legal and financial liabilities. Airspan and its resellers
or distributors are not liable for injury, damage or violation of regulations associated with the
installation of outdoor units or antennas.
 The AU540 eNB B41 module does not provide protection from hazard energy in case of
single fault condition.
 Power supply shall be limited up to 4A in normal and single fault condition.
Important Safety Instructions
 Read and Save these instructions
 This Installation Guide contains instructions and warnings that should be followed during
installation, and operation.
 Failure to follow these instructions could cause bodily injury and/or product failure
Safety
1. Read this guide and follow all operating and safety instructions.
2. Supply cord is not shipped with the unit and is to be provided by user. Installation is to be
performed by a qualified electrician according to local codes. Installation to be done in
accordance with the National Electrical Code (NEC), ANSI/NFPA 70, the Canadian
Electrical Code (CEC), Part I, CAN/CSA C22.1, and when applicable, the National
Electrical Safety Code, IEEE C2.
3. Static sensitive components inside - do not remove the lid or base: No user serviceable
parts inside.