User's Manual

AU540 eNB B41 User Guide
UGD-D01112 Airspan Commercial and Internal Use 8
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
 Consult the dealer or an experienced technician for help.
Note: The AU540 eNB B41 module is intended for use internally in the Airspan products.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance of 20 cm between the
radiator & your body. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the two (2) conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed.
IMPORTANT NOTE:
In the event that these conditions cannot be met (for example certain laptop configurations or co-
location with another transmitter), then the FCC authorization is no longer considered valid and the
FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
The OEM integrator must not provide information to the end user regarding how to install or remove
this RF module.
Labeling Requirement
When the module is installed inside another device, then the outside of the device into which the module
is installed must also display a label referring to the enclosed module.
This exterior label must include wording similar to the following:
 ‘‘Contains Transmitter Module FCC ID: PIDAU540ENB25’’
 ‘‘Contains FCC ID: PIDAU540ENB25’’