User's Manual
Table Of Contents
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
- ProST Frequency Ranges
- Main Features
- Architecture
- ProST Protocol Stack
- Theory of Operation
- Package Contents
- Minimum PC Requirements
- Required Tools
- Radio Site Planning
- ProST Physical Description
- SDA-1 Physical Description
- SDA-4S Type II and SDA-4S/VL Type II (Optional)
- Mounting the ProST
- Wall Mounting
- Pole Mounting
- SDA-4S
- Connecting to IDU
- Connecting to LAN Network
- Connecting AC/DC Power Adapter
- Mounting AC/DC Power Adapter
- DC Power Source
- AC Power Source
- Connecting Lightning and Surge Protector
- Antenna Alignment using RSSI LED Plug Adapter
- LED Status
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
- 1.7 CAUTION
- 1.8 Lightning Protection
605-0000-706 ProST Installation User Guide-Rev E
24
3. Insert wall anchors (not supplied) into each of the drilled holes.
4. Align the mounting bracket's four holes with the wall anchors, and then insert a screw (not
supplied) through the mounting bracket holes into each wall anchor, and tighten.
Note: Airspan does not provide screws for attaching the mounting bracket to the wall. The
screw size depends on the structure of the building to which the bracket is to be attached.
When selecting screw sizes, consideration must be given to the weight of the ProST and load
that may be induced in windy conditions.
5. Attach the ProST to the mounting bracket by performing the following:
a. Slide an M10-spring lock washer and then an M10-plain washer onto each M10-hex head
screw (ensure lock washer is nearest to head of screw bolt).
b. Align the mounting bracket's holes with the ProST's mounting holes as displayed below.
(The mounting bracket side that provides a groove for inserting a nut must be aligned with
the ProST's mounting hole that is nearest to the ProST's rear panel.)
c. From the external sides, insert the M10-hex head screws through the mounting bracket's
holes and ProST's mounting holes. Loosely fasten with the M10-hex nuts.