User's Manual

RSSI LED Plug Adapter
65
LED Status
The RED Power LED functions as follows:
Status Description
ON ProST receiving power from SDA
OFF No power being received
Blinking Data transmission via Ethernet LAN
The LED status for each RSSI level is defined in the following table:
RSSI Level dB LED 0 LED 1 LED 2 LED 3 LED 4 LED 5 LED 6 LED 7
97dB- 0 0 0 0 0 0 0 0
93 - 96 1 0 0 0 0 0 0 0
89 - 92 1 1 0 0 0 0 0 0
83 - 88 1 1 1 0 0 0 0 0
79 - 82 1 1 1 1 0 0 0 0
75 - 78 1 1 1 1 1 0 0 0
71 - 74 1 1 1 1 1 1 0 0
67 - 70 1 1 1 1 1 1 1 0
66 dB+ 1 1 1 1 1 1 1 1
Before connecting the power adapter to the ProST, you need to connect the AC power cable (that
connects to the subscriber,s power outlet) to the adapter, as described in the following procedure.
To connect the RSSI LED Plug Adapter:
1. Connect the 15-pin D-type male connector, at one end of the straight-through cable, to the
ProST.
2. Connect the 15-pin D-type female connector, at the other end of the straight-through cable
from the ProST, to the RSSI LED adapter.
3. Connect the 15-pin D-type male connector, at one end of the straight-through cable, to the
SDA.
4. Connect the 15-pin D-type male connector, at the other end of the straight-through cable
from the SDA, to the RSSI LED adapter.
Note: You can connect the RSSI LED Plug adapter's 15-pin male port directly to the ProSt's
15-pin female port, instead of using a cable.
The following diagram illustrates the RSSI LED plug connections: