User's Manual

ManualsBrandsAirspan Networks ManualsElectronicsSubscriber (terminal) station

Table Of Contents

INTRODUCTION
- Purpose
- Targeted Audience
- Referenced Documentation
- Conventions
WARNINGS AND CAUTIONS
- Human Exposure to Radio Frequencies
- Radio Interference
- Avoiding Radio Interference
- Modifications
- General
- Manufacturer's Disclaimer Statement
DECLARATION OF CONFORMITY
- European Community, Switzerland, Norway, Iceland, and Liecht
- Declaration of Conformity with Regard to the R&TTE Directive
FCC INTERFERENCE STATEMENT
- Federal Communication Commission Interference Statement
- Maximum Output TX Power
SYSTEM OVERVIEW
- ProST Frequency Ranges
- Main Features
- Architecture
  - ProST Models
  - ProST Block Diagram
- ProST Protocol Stack
- Theory of Operation
INSTALLATION PREREQUISITES
- Package Contents
- Minimum PC Requirements
- Required Tools
- Radio Site Planning
PHYSICAL DESCRIPTION
- ProST Physical Description
  - Physical Dimensions
  - Port
- SDA-1 Physical Description
- SDA-4S Type II and SDA-4S/VL Type II (Optional)
- SDA-4SDC Type II (Optional DC power supply)
MOUNTING THE PROST
- Mounting the ProST
- Wall Mounting
- Pole Mounting
- SDA-4S
  - Desktop Mounting
  - Wall Mounting
NETWORK CABLING
- Connecting to IDU
  - Using the SDA-1 Type II
  - Using the SDA-4S Type II, SDA-4S/VL Type II or SDA-4S/DC Typ
- Connecting to LAN Network
CONNECTING TO POWER
- DC Power Source
- Connecting the SDA-4SDC Type II (Optional DC adapter)
- AC Power Source
  - Using SDA-1 Type II
  - Using SDA-4S Type II and SDA-4S/VL Type II
CONNECTING POWER CABLE FOR SDA-4SDC
- Power Cable Connection
  - Housing the Connectors
  - Connecting to the SDA-4SDC
CONNECTING LIGHTNING AND SURGE PROTECTOR
- PolyPhaser Wiring Diagram
  - Lightning and Surge Protection Connection Scenarios
RSSI LED PLUG ADAPTER
- Antenna Alignment using RSSI LED Plug Adapter
- LED Status
CONNECTING EXTERNAL ANTENNA
TROUBLESHOOTING
TRADEMARKS AND COPYRIGHTS
CONTACT INFORMATION
REVISIONS
WARNINGS
- 1. Disclaimer
- 1.1 Safety Warnings
- 1.2 Important Warning Symbols
- 1.3 Important Service Information
- 1.4 UL Information
- 1.5 CE Notice
- 1.6 European Community, Switzerland, Norway, Iceland, and L
  - Declaration of Conformity with Regard to the R&TTE Directive
- 1.7 CAUTION
- 1.8 Lightning Protection
GLOSSARY
INDEX

Mounting the ProST

6. Adjust the horizontal positioning of the ProST, and then tighten the two M10-hex head

screws with the M10 hex nuts.

Note: A third-party thread-locking compound must be applied to the M10-hex head screws

to prevent the bolts from working loose.

Rotation is restricted in the horizontal plane only, as shown in the figure below:

Pole Mounting

Pole mounting allows the ProST to be easily adjusted in the horizontal (azimuth) and vertical

(elevation) planes for antenna alignment. The ProST is mounted using the mounting holes located