User's Manual
Table Of Contents
- 605-0000-703
- EasyST 4.9 Installation Guide
- Read the Warnings and Cautions before installing or working on this equipment.
- WARNINGS
- DECLARATION OF CONFORMITY
- FCC INTERFERENCE STATEMENT
- ABOUT THIS GUIDE
- SYSTEM OVERVIEW
- GETTING STARTED
- PHYSICAL DESCRIPTION
- CONNECTING EASYST TO A PC
- CONNECTING EASYST TO POWER
- MOUNTING EASYST
- OPTIMIZING PERFORMANCE
- RESETTING TO DEFAULT SETTINGS
- ATTACHING CLIP-ON ANTENNA
- SPECIFICATIONS
- TROUBLESHOOTING
- GENERAL
- REVISIONS
- CONTACT INFORMATION
- COPYRIGHT INFORMATION
- WARNINGS AND CAUTIONS
- GLOSSARY
- INDEX
605-0000-703 EasyST 49 Installation User Guide-Rev D
26
3. For customers possessing EasyST models that implement a screw mechanism for securing
the antenna to the EasyST, continue with the following steps:
a. Flip the EasyST over so that its rear panel is visible. Insert the M3 25-mm flat-head Philips
screw (supplied) into the hole that's located on the rear panel, behind the RJ-45 and DC
power connectors, as shown in the figure below.
b. Using a Philips screwdriver, tighten the screw so that the antenna is firmly attached to the
EasyST.