User's Manual

17
CONNECTING EASYST TO A PC
EasyST provides 10/100BaseT (Fast Ethernet) interface with the subscriber's network. The
connectivity is performed through the supplied Category 5 Ethernet cable consisting of 8-pin RJ-45
connectors on either end.
The EasyST-to-computer cable setup is listed below:
Cable: straight-through CAT 5 STP Ethernet cable
Connector: 8-pin RJ-45
Connector pinouts (for both ends):
Pin Function
1 Tx+
2 Tx-
3 Rx+
6 Rx-
To connect EasyST to the subscriber's network:
1. Plug the RJ-45 male connector, located at one end of the Category 5 Ethernet cable, into
the EasyST's 8-pin RJ-45 port.
2. Plug the RJ-45 male connector, located at the other end of the Category 5 Ethernet cable,
into your computer's LAN port.
The figures below illustrate the EasyST-to-computer cable connection: