User's Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 Mounting the ProST
- 6 Network Cabling
- 7 Connecting to Power
- 8 Power Cable Connection
- 9 Connecting Lightning and Surge Protector
- 10 RSSI LED Plug Adapter for Antenna Alignment
- 11 Connecting External Antenna
- 12 Appendix
ProST Hardware Installation User Guide
Page 65 Commercial in Confidence UWB-D00111 Rev L
10.1 LED Status
The RED Power LED functions as follows:
Table16‐LEDStatus
Status Description
ON
ProST receiving power from SDA
OFF
No power being received
Blinking
Data transmission via Ethernet LAN
The LED status for each RSSI level is defined in the following table:
Table17‐LEDStatusperRSSIlevel
RSSI Level dB LED 0 LED 1 LED 2 LED 3 LED 4 LED 5 LED 6 LED 7
97dB-
0 0 0 0 0 0 0 0
93 - 96
1 0 0 0 0 0 0 0
89 - 92
1 1 0 0 0 0 0 0
83 - 88
1 1 1 0 0 0 0 0
79 - 82
1 1 1 1 0 0 0 0
75 - 78
1 1 1 1 1 0 0 0
71 - 74
1 1 1 1 1 1 0 0
67 - 70
1 1 1 1 1 1 1 0
66 dB+
1 1 1 1 1 1 1 1
Before connecting the power adapter to the ProST, you need to connect the AC power cable (that
connects to the subscriber’s power outlet) to the adapter, as described in the following procedure.
To connect the RSSI LED Plug Adapter:
1. Connect the 15-pin D-type male connector, at one end of the straight-through cable, to the
ProST.
2. Connect the 15-pin D-type female connector, at the other end of the straight-through cable
from the ProST, to the RSSI LED adapter.
3. Connect the 15-pin D-type male connector, at one end of the straight-through cable, to the
SDA.
4. Connect the 15-pin D-type male connector, at the other end of the straight-through cable
from the SDA, to the RSSI LED adapter.
Note: You can connect the RSSI LED Plug adapter's 15-pin male port
directly to the ProSt's 15-pin female port, instead of using a cable.