User's Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 Mounting the ProST
- 6 Network Cabling
- 7 Connecting to Power
- 8 Power Cable Connection
- 9 Connecting Lightning and Surge Protector
- 10 RSSI LED Plug Adapter for Antenna Alignment
- 11 Connecting External Antenna
- 12 Appendix
ProST Hardware Installation User Guide
Page 56 Commercial in Confidence UWB-D00111 Rev L
Figure43‐ProSTtopower
Verify that your SDA-1 Type II is on and receiving power by checking that the LED labeled
POWER is lit (see
2SDA-1 Type II LED description). If it is not lit, see 2Troubleshooting.
7.3.1.3 Using SDA-4S Type II and SDA-4S/VL Type II
The SDA-4S adapters are plugged into a standard electrical wall outlet (110/240 VAC) using an
AC power cord. The appropriate AC power cord is supplied according to the country of use.
The cable setup between the SDA-4S and power outlet includes the following:
¾ Connector: AC IEC 60320 type (female)
¾ Plug: The appropriate plug type is supplied according to the country of use
¾ Cable: 3x1.z0 mm, 10A / 250 VAC (maximum length is 180 cm)
Figure44‐Powercord
To connect the SDA-4S to the AC power supply:
1. Connect the power plug female, at the end of the AC power cord, into the AC power socket
located on the left panel of the SDA-4S.
2. Plug the power plug male, at the other end of the AC power cord, into the AC power outlet
(110-240 VAC).