User Manual
Table Of Contents
EasyST Hardware Installation User Guide
Page 42 Commercial in Confidence UWB-D00128 Rev K
Figure27‐clip‐onantenna
4. Gently push the antenna down onto the EasyST so that the MCX and 6-pin connectors plug
into their respective receptacles, and that the antenna's knob sits firmly into the EasyST's
notch.
Figure28‐antennaattached
5. For customers possessing EasyST models that implement a screw mechanism for securing
the antenna to the EasyST, continue with the following steps:
a. Flip the EasyST over so that its rear panel is visible. Insert the M3 25-mm flat-head Philips
screw (supplied) into the hole that's located on the rear panel, behind the RJ-45 and DC power
connectors, as shown in the figure below.