User Manual

EasyST Hardware Installation User Guide
Page 41 Commercial in Confidence UWB-D00128 Rev K
9 Replacing the Clip-On Antenna
The EasyST is supplied with the clip-on antenna already attached to the EasyST. However, in
cases where you may have previously removed it to connect EasyST to an external window-
mount antenna, you may want to discontinue using the external antenna and replace it with the
clip-on antenna.
Caution: Before disconnecting the external antenna and replacing the clip-on
antenna, ensure that the EasyST is not connected to the power source. Do
not connect and disconnect antennas while the power is on. This can cause
irreversible damage to the EasyST.
Note: Later EasyST models provide a screw for securing the clip-on antenna
to the EasyST.
To replace the clip-on antenna:
1. Remove the plastic protection cap protecting the antenna connectors, by inserting a flat-
head screw driver between the cap and the EasyST, and then gently leveraging the cap's
guides out of the EasyST's cover pins.
Figure25‐Removecover
2. Unplug the external antenna's MCX connector from the EasyST's MCX jack.
Figure26‐UnplugMCXconnector
3. Align the clip-on antenna's knob with the EasyST's notch, as shown in the figure below.