User Manual

EasyST Hardware Installation User Guide
Page 38 Commercial in Confidence UWB-D00128 Rev K
Figure20‐installplasticcap
Note: If you later decide to disconnect the external antenna and reconnect
the clip-on antenna, see Replacing the Clip-On Antenna
.
8.2 Mounting the External Antenna
The external antenna can be easily mounted in a vertical position on a window using the adhesive
pads located on the side and front panels of the antenna. The antenna can be mounted in one of
two orientations:
¾ Antenna's front panel (narrow edge) is mounted flat against the window (typical
orientation)
¾ Antenna's side panel is mounted flat against the window
Note: The external antenna must be mounted on a flat, smooth, dry, and
clean surface (i.e. window).
To window-mount the external antenna:
1. Locate the desired position on the inside of a window to where you want to mount the
antenna.
2. Remove the white tape from the adhesive pads. Do not touch the adhesive surfaces.
3. Align the antenna vertically just above the window surface to where you want to mount the
antenna, in the desired orientation (as described above).
4. Press the antenna down firmly onto the window surface so that all adhesive pads touch at
the same time. Put pressure on all the areas under which are located adhesive pads.