User Manual
Table Of Contents
EasyST Hardware Installation User Guide
Page 37 Commercial in Confidence UWB-D00128 Rev K
Caution: Do not rotate the clip-on antenna until it has detached entirely from
the EasyST.
2. Remove the plastic protector cap to expose the MCX female connector. Insert a flat-head
screw driver (or any tool with a blunt, pointed edge), into the cable groove created by the cap
and the EasyST, and then gently leverage the cap's guides out of the EasyST's cover pins.
Figure18‐removeplasticcover
3. Plug the external antenna's MCX connector into the EasyST's MCX female connector, as
shown below.
Figure19‐connectingantenna
4. Feed the RF cable into the EasyST's RF cable groove, ensuring that the RF cable exits the
EasyST through the EasyST's RF cable groove, as shown above.
5. Protect the connectors by covering the area exposed by the removal of the clip-on antenna,
with the plastic protector cap (supplied). Attach the plastic protector cap to the exposed area,
by aligning the cap's two position cups with the EasyST's two position pins. Ensure that the
cap's RF cable groove is aligned and flush with the RF cable and EasyST's RF cable groove.