User Manual

EasyST Hardware Installation User Guide
Page 32 Commercial in Confidence UWB-D00128 Rev K
wall, the EasyST provides two mounting hooks molded into EasyST's bottom panel, as shown
below:
Figure13‐Wallmounting
Note: Before mounting the unit, ensure that the RF cable of the window-
mount external antenna is plugged into the EasyST's MCX connector and
that the cover cap is fitted onto the EasyST, protecting the MCX connector.
To wall mount the EasyST:
1. On the wall, mark the position where you want to drill the two holes for the screws on to
which the two mounting hooks will later by guided. The distance between the two wall-
mounting hooks (from their centers) is 83 mm (3.27 inches). Ensure that the holes are
aligned and level using a spirit level.
2. Drill holes for each hole that you marked in the step above, using a no. 6 twist drill bit.
3. Insert the 6-mm wall anchors (supplied) into each of the drilled holes.
4. Drive the two 0.75-inch screws (supplied) into the wall anchors. Ensure that at least 0.08-
inch gap is exposed between the screw head and the wall anchor to allow insertion into the
EasyST mounting hooks.
5. Align the entrance to the two EasyST mounting hooks with the screws, and then pull down
the EasyST to lock the screws into the mounting hooks.