User Manual

EasyST Hardware Installation User Guide
Page 27 Commercial in Confidence UWB-D00128 Rev K
5 Cabling
Cabling your EasyST is fast and simple, and consists of the following:
¾ Connecting EasyST to a computer
¾ Connecting EasyST to power
¾ Verifying correct cabling
5.1 Connecting EasyST to a Computer
EasyST provides 10/100BaseT (Fast Ethernet) interface with the subscriber's network. The
connectivity is performed through the supplied Category 5 Ethernet cable consisting of 8-pin RJ-
45 connectors on either end.
The EasyST-to-computer cable setup is as follows:
¾ Cable: straight-through CAT 5 Ethernet cable
¾ Connector: 8-pin RJ-45
¾ Connector pinouts:
Table10pinouts
Pin Function
1 Rx+
2 Rx-
3 Tx+
6 Tx-
To connect EasyST to the subscriber's network:
1. Plug the supplied Category 5 Ethernet cable into the EasyST's 8-pin RJ-45 port.
2. Plug the other end of the Category 5 Ethernet cable into your computer's LAN port located at
the back of your computer.
The figure below illustrates the CAT 5 cable connection to the EasyST's RJ-45 port:
Figure8‐cableconnection
The figure below illustrates the CAT 5 cable connection to the computer's LAN port: