User Manual
Table Of Contents
- 1 About this Guide
- 2 System Overview
- 3 Installation Prerequisites
- 4 Physical Description
- 5 Mounting the ProST
- 6 Network Cabling
- 7 Connecting to Power
- 8 Power Cable Connection
- 9 Connecting Lightning and Surge Protector
- 10 RSSI LED Plug Adapter for Antenna Alignment
- 11 Connecting External Antenna
- 12 Appendix
ProST Hardware Installation User Guide
Page 43 Commercial in Confidence UWB-D00111 Rev K
Figure31‐SDA‐4Smountingtemplate
2. Drill holes for each hole that you marked in the step above.
3. Insert wall anchors (supplied) into each of the drilled holes.
4. Insert the 9-inch screws (supplied) into the wall anchors. Ensure at least 2 mm of the screw
is exposed to allow insertion into the SDA-4S mounting holes.
5. Hold the SDA-4S with both hands, and align the entrance to the two mounting hooks with the
screws. Slide the screws into the mounting hooks, by lowering the SDA-4S onto the screws.
Note: For safety, both mounting hooks must be utilized when mounting the
unit.
Note: The SDA-4S is supplied with a 1-metre AC power lead assembly.
Therefore, ensure the unit is mounted within reachable distance to the
customer's mains power outlet.
Note: The maximum cable run between SDA-4S and ProST is 100 meters.
Therefore, ensure the unit is mounted within reachable distance.