Installation Guide

AirSpeed 2900 gNB 5G OD Installation Guide

Figure 6: Position on Pole

6. Insert a clinch clamp on the two (2) upper threaded rods and put on washers and nuts and

hand tighten.

7. Insert the bottom clinch clamp on the two (2) lower threaded rods and put on washers and

nuts and hand tighten, as shown below:

Figure 7: Mounting Bracket on Pole

8. Tighten all four (4) nuts. Fastening torque of 132 [Lib*in] = [151.8 kgf*cm].

9. Using the lifting handle, carefully lift and align and position the unit so that the lower screws

(1 on each side) fit into the notched grooves provided on the back bracket (pre-assembled

on the unit) and hand tighten. Insert the upper 1/4-20 screws, washers and nuts (supplied)

and fasten the back bracket to the mounting bracket.

10. Carefully align and position the unit so that the screws (1 on each side) fit into the notched

grooves provided on the Tilt bracket (pre-assembled on the unit) and hand tighten. Insert

the 1/4-20 screws, washers and nuts (supplied) and fasten the Tilt bracket (pre-assembled

on the unit) to the mounting bracket.

11. Adjust the unit so that the GPS is positioned upright. Check and tighten all fixing screws.

(Tighten to a torque of no more than 12.5 Nm (9.22 ft-lb) max.).