Installation Guide

AirSpeed 1050 Installation Guide
DUG01545 Airspan Commercial and Internal Use 42
A Job Sheet
This job sheet enables the users to keep track of their installation. It covers all the prerequisites
required for accomplishing the AirSpeed 1050 installation.
Site Requirements
o Pole or Wall for installation identified
o Position on pole or wall identified
o Access restrictions (highway regulations, other services on pole, power
pole)
o Method of reaching desired positions (ladders, Elevated work platform)
o Main fuse block available (where needed)
o Configuration programming details known
o All equipment items available at the installation site
o AirSpeed 1050 unit + mounting kit
Tools
(For further information, see Verify the Tools.)
o Large flat screw driver for pole clamps
o Small flat blade screw driver (insulated shaft recommended)
o Appropriate wrench’s for unit assembly
o Knife
o pliers
o Small side cutters
o Tweezers (or fine blade long nose pliers)
o Wire strippers
Required Ancillary Equipment
o Laptop PC for initial configuration
o cable for temporary connection of the lap top