Installation Guide

AirSpeed 1050 Installation Guide
DUG01545 Airspan Commercial and Internal Use 32
Caution: Verify the wire polarity before securing.
Figure 32: Tighten Two (2) Set Screws
7. Tighten the strap clamp screw as shown below.
Figure 33: Tighten the Strap Clamp
8. Insert into outer housing until “click” in place, align marks for proper alignment.
Figure 34: Align Marks + Click in Place
9. Place the split rubber gland onto the cable.
Figure 35: Place Split Rubber Gland
For recommended gland size see Table 9: Recommended Gland Size
Note: The gland size is written on the edge of the gland.