Installation Guide

AirSpeed 1030 B48 Installation Guide
DUG01623 Airspan Commercial and Internal Use 40
Figure 43: Insert Gland Nut
5. Loosen the strap clamp and feed the prepared end of the source power cable into the inner
part of the DC connector housing.
Figure 44: Pass DC Cable Thru
6. Secure the prepared ends of the cable into the inner part of the connector housing and
tighten the 2 screws.
Caution: Verify the wire polarity before securing.
Figure 45: Tighten Two (2) Set Screws
7. Tighten the strap clamp screw as shown below.
Figure 46: Tighten the Strap Clamp
8. Insert into outer housing until “click” in place, align marks for proper alignment.