Installation Guide

AirSpeed 1030 B48 Installation Guide
DUG01623 Airspan Commercial and Internal Use 36
Figure 29: Gland Nut on Cable
3. Insert the “split tightening cone” from the side of the cable.
Figure 30: Insert Tightening Cone on Cable
4. Insert the “split rubber gland” from side of the cable.
Note: Inner diameter of rubber gland is in the 5.8mm to 6.8mm or 8.8mm to 9.8mm range. Make
sure to select the correct gland size.
Figure 31: Insert Rubber Gland on Cable
5. Insert the housing onto the RJ45 cable.
Figure 32: Insert Housing onto Cable
6. Insert the holder section onto the front of the RJ45.