Installation Guide

AirSpeed 1030 B48 Installation Guide
DUG01623 Airspan Commercial and Internal Use 32
2. Open the housing lock by sliding up then lift the clamp handle,
Figure 14: Open Housing Lock
3. Separate the housing into its component sections.
4. Insert the gland nut through the front end of LC Duplex assembly.
Figure 15: Gland Nut on Cable
5. Insert the “split tightening cone” from the side of the cable.
Figure 16: Insert Tightening Cone on Cable
6. Insert the “split rubber gland” from side of the cable.
Note: Make sure to select the correct gland size. Inner diameter of rubber gland is in the range of
4.8 to 6.8mm (0.19”-0.26”) range.
Figure 17: Insert Rubber Gland on Cable
7. Pass the LC Duplex cable thru the housing.