User's Manual
Table Of Contents
- Hardware Installation Guide
- Contents
- About this Guide
- 1. Overview
- 2. Safety Guidelines
- 3. Package Contents
- 4. Required Tools
- 5. Radio Site Planning
- Part I: Base Station Installation
- Part II: CPE Installation - Subscriber Premises Radio (SPR)
- Part III: CPE Installation - Indoor Data Radio Indoor (IDR)
- A. Glossary
- B. Installing the BSPS
- B.1. Basic Design
- B.2. Physical Dimensions
- B.3. Electrical Site Requirements
- B.4. BSPS Cabinet Cabling
- B.5. Installation Summary
- B.6. BSPS Batteries
- B.7. Rectifiers
- B.8. Operating the System Controller
- B.9. Powering on BSPS
- B.10. Connecting BSPS Management Cables
- B.11. Cabinet Power Requirements
- B.12. Troubleshooting
- C. Cable Crimping
- D. Connector Pinouts for SPR with DB9
- E. Evaluating Link Quality
- F. Technical Specifications
- G. Third-Party External Antenna Specifications
- H. Declaration of Conformity
Contents Hardware Installation Guide
xii Airspan Networks Inc. 02030311-07
B.4. BSPS Cabinet Cabling........................................................................B-6
B.5. Installation Summary .......................................................................... B-8
B.6. BSPS Batteries .................................................................................B-10
B.6.1. Installing .............................................................................B-10
B.6.2. Determining Battery Size ...................................................B-13
B.7. Rectifiers...........................................................................................B-14
B.7.1. Installing .............................................................................B-14
B.7.2. Calibrating ..........................................................................B-15
B.8. Operating the System Controller....................................................... B-16
B.9. Powering on BSPS ........................................................................... B-18
B.10. Connecting BSPS Management Cables ......................................... B-19
B.11. Cabinet Power Requirements ......................................................... B-19
B.11.1. Cabinet Grounding ...........................................................B-22
B.11.2. Equipment Supplementary Grounding ............................. B-22
B.12. Troubleshooting .............................................................................. B-23
C. Cable Crimping.........................................................................................C-1
C.1. IDC Crimping of CAT 5 Cables to 15-pin D-Type Connectors............C-2
C.1.1. CAT 5 Wire Color-Coding ....................................................C-4
C.1.2. Crimping...............................................................................C-5
C.1.3. Inspecting the Crimped Connector ......................................C-7
C.1.4. Assembling the Connector Hood .........................................C-7
C.1.4.1. Outdoor Units ........................................................C-8
C.1.4.2. Indoor Units .........................................................C-10
C.2. Crimping N-type Connectors ............................................................C-13
C.2.1. Stripping the Cable ............................................................C-13
C.2.2. Assembling the Connector.................................................C-14
C.2.3. Crimping.............................................................................C-16
C.3. Crimping GPS Cable Connectors .....................................................C-17