User's Manual

Hardware Installation Guide Mounting the Devices

02030311-10 Airspan Networks Inc. 7-5

b. Choose an elevation hole on the mounting bracket and then align it with

the corresponding hole on the clamping bracket. Slide an M6-spring lock

washer onto an M6-hex head screw, and then from the external side of

the mounting bracket, insert the M6-hex head screw through the

elevation hole on the mounting bracket and into the clamping bracket's

corresponding hole. Fasten but not tightly the M6-hex head screw (the

clamping bracket provides built-in nut). The elevation hole can later be

changed according to desired antenna orientation in the elevation plane.

Figure 7-5: Clamping bracket attached to mounting bracket

3. Attach the U-bolt to the pole:

a. Place one U-bolt around the pole, and then insert the U-bolt screw side

through the two corresponding holes (horizontally parallel) on the

clamping bracket. Slide an M8-flat washer and M8-spring lock washer

onto each U-bolt screw side (ensure that the flat washer is adjacent to the

clamping bracket). Fasten each U-bolt side with the two M8-hex nuts.

b. Attach the second U-bolt as described above.

Pivot hole

Clamping

racket

Selected

elevation hole