User's Manual

02030311-10 Airspan Networks Inc. 7-1
Mounting the Devices
Mounting the DevicesMounting the Devices
Mounting the Devices
This chapter describes the mounting procedures for the following devices:
 BSR
 BSDU
 BSPS
7.1. Pole Mounting BSR
The BSR is typically mounted outside on a pole, but it can also be mounted outside
on a wall. Pole mounting allows the BSR to be easily adjusted in the horizontal
(azimuth) and vertical (elevation) planes for antenna alignment.
Warning: The BSR device is an outdoor radio unit, and therefore, must only be
mounted outside.
Note: In the standard BSR kit, Airspan does not supply wall-mounting
brackets. To order wall-mounting brackets, contact your Airspan
representative. BSR wall mounting is identical to SPR wall mounting (see Part
II, Chapter 13, "Mounting the Devices").
The BSR is mounted using the mounting holes located on the BSR's bottom panel
(see Figure 7-1) and the supplied pole-mounting brackets. The pole-mounting
bracket is designed to support the BSR on a round pole of 45 mm in diameter.
8 7