User's Manual

Installing the BSR Hardware Installation Manual
4-6 Airspan Networks Ltd. 02030311-03
4.4. Connecting the BSR for Serial
Configuration
The BSR’s 15-pin D-type port provides serial interface to a PC for BSR initial
configuration. This port uses 9 of its 15 pins for serial interface; the remaining pins
are used for interfacing with the BSDU or SDA with which the BSR is connected.
To connect the BSR to the PC and the SDA or BSDU, a Y-cable is used.
Note: For performing BSR initial configuration using WipLL’s management
applications, refer to WipConfig User’s Guide and WipConfig PDA User’s
Guide.
The BSR-to-PC management station serial cable connections include the following
! Connectors:
! BSR: 15-pin D-type male (only 9-pins used)
! PC: 9-pin D-type (RS-232)
! SDA/BSDU: 15-pin D-type male
! Cable: straight-through Y-cable
Figure 4-3: Y-Cable (P1 for BSR; J1 for SDA/BSDU; J2 for PC’s serial port)