Installation Instructions

Installing the IDR Hardware Installation Guide
12-22 Airspan Networks Inc. 02030311-07
Prior to connecting to the power outlet, the following pre-connection inspection
should be performed on power sockets:
Ensure no other equipment is connected to the power outlet.
Ensure no physical sign of damage to the power outlet.
Ensure no water or dampness on or around the power outlet.
Ensure plug and socket assemblies are firmly secured.
Check the power outlet to verify the earth loop impedance value and the
presence of phase, neutral and earth connections using a proprietary plug tester
such as a ‘Martindale Ze’ type.
The IDR-to-power cable set up is as follows:
Cable: 3-core 0.7mm² type
Connector: 6-Pin power connector
Connector pinouts:
Pin Function
1 +6.5V
2 +5V
3 3.3V
4 GND
5 Not connected
6 Not connected
To connect the power:
1. Plug the AC power adapter’s 6-pin Molex connector into the IDR’s power port
labeled Power (see Figure 12-14).
2. Plug the AC power plug female, at the one end of the AC power cable, into the
AC power adapter’s socket (see Figure 12-14).
3. Plug the AC power plug male, at the other end of the AC power cable, into the
electrical outlet (see Figure 12-14).