Installation Instructions

Installing the IDR Hardware Installation Guide
12-18 Airspan Networks Inc. 02030311-07
12.6. Connecting to PC for Serial Configuration
To perform IDR initial configuration, you need to connect the IDR’s RJ-11 port to
the serial port of a PC running the WipLL network management application (i.e.,
WipConfig).
The IDR’s RJ-11 port labeled Serial, located on the front panel, connects to the
serial port of a PC. This is performed using two cables (straight through and
crossover) and an RJ-11-to-9 pin D-type female adapter on the crossover cable.
 Connectors:
 6 pin RJ-11 male (to IDR)
 6 pin RJ-11 male (to adapter)
 6 pin RJ-11-to-9 pin D-type female adapter
 9 pin D-type male (to adapter)
 9 pin D-type female (to PC)
 Cable:
 Straight-through cable with 6-pin RJ-11 connectors on both sides: one for
IDR and one for the RJ-11-to-9 pin D-type adapter (connects straight-
through to crossover cable)
 Crossover cable with RJ-11-to-9 pin D-type adapter on one end and 9-pin
D-type female on the other that connects to the PC