Installation Instructions

Hardware Installation Guide Installing the IDR
02030311-07 Airspan Networks Inc. 12-13
Warning: It is the responsibility of the person installing the WipLL system
to ensure that when using the outdoor antenna kits in the United States (o
r
where FCC rules apply), that only those antennas certified with the product are
used. The use of any antenna other than those certified with the product is
expressly forbidden in accordance with FCC rules CFR47 part 15.204. The
installer should configure the output power level of antennas according to
country regulations and per antenna type.
Warning: Indoor units and antennas should be installed ONLY by experienced
installation professionals who are familiar with the local building and safety
codes and are licensed by the appropriate government authorities
Warning: In accordance with FCC regulations, ensure that when operating in
unlicensed bands, the external antennas provide a maximum EIRP of 36 dBm
to prevent interference with other radios operating in the unlicensed band. The
EIRP is defined as:
Max. Power Output + Antenna Gain + Cable Loss ≤ 36 dBm (EIRP)
Warning: When using external antennas, the external antennas must not be
co-located or operating in conjunction with any other antenna or transmitter.
12.4. Connecting to an Ethernet Network
The IDR provides one Ethernet interface for the subscriber’s Ethernet network. This
port is located on the front panel, and labeled Ethernet.
The IDR-to-Ethernet network cable set up is as follows:
 Cable: CAT-5
 Connector: 8-pin RJ-45
 Connector pinouts:
Cat 5 cable
8-pin RJ-45
Pin Function