User's Manual Part 2b

Hardware Installation Guide Installing the BSPS

02030311-05 Airspan Networks Ltd. 7-17

To calibrate the rectifier:

1. Remove the rectifier from the unit.

2. Connect the Share (+) bus to the negative pole (-) of the rectifier.

3. Using a DMM set the output voltage to 53.50 VDC.

4. Check the single rectifier using a female connector (such as the one used in the

units of the system).

5. Perform provisions for the calibration on a dedicated unit.

6. Access the trimmer via the small opening at the back of the cover.