User's Manual

Hardware Installation Manual Installing and Configuring the IDR
02030311-03 Airspan Networks Ltd. 10-19
10.4.2. Configuring the SPR using WipConfig
When you connect the IDR to a PC, the configuration screen shown in Figure 10-13
is displayed. The parameters will be those read from the target device. (Data source:
TARGET).
To change parameters type the new values into the fields ensuring that the old data is
overwritten. An asterisk (*) will appear to indicate that the changes were not set and
saved. Use the Write button to set the changes to the target device then reset the
target to activate the changes.
Figure 10-13: IDR initial configuration using WipConfig