Manualshelf

Installation Guide

ManualsBrandsAirspan Networks ManualsElectronicsHybrid System Tranceiver
11121314151617181920
Hardware Installation Guide About This Guide
02030311-08 Airspan Networks Inc. xv
Chapter 13, "Mounting the Devices"
Chapter 14, "Network Cabling"
Chapter 15, "Serial Cabling"
Chapter 16, "Connecting Third-Party External Antennas"
Chapter 17, "Antenna Alignment using RSS LED Adapter"
Chapter 18, "Power Cabling"
Part 3, "CPE Installation - IDR": includes the following chapters concerned
with installing an IDR at the subscriber's premises:
Chapter 19, "Basic Design"
Chapter 20, "Mounting"
Chapter 21, "Network Cabling"
Chapter 22, "Serial Cabling"
Chapter 23, "Connecting Third-Party External Antenna"
Chapter 24, "Antenna Alignment using RSS LEDs"
Chapter 25, "Power Cabling"
Appendix A, "Glossary": glossary of terms used in this guide
Appendix B, "Installing the BSPS": describes the procedures for installing an
optional third-party Base Station Power System.
Appendix C, "Cable Crimping": describes the crimping procedure for 15-Pin
D-type, N-type, and GPS connectors.
Appendix D, "RSS Led Plug Cabling for SPR with DB9 Port": describes
connector pinouts for SPR-to-RSS LED Adapter cabling when the old SPR
model that provides a 9-pin D-type port is used.
Appendix E, "RJ-45 to DB15 Adapter for IDU/ODU Connectivity": describes
the use of an optional RJ-45 to DB15 adapter for connecting the outdoor radio to
the indoor hub/switch.