User Manual

Installing the BSR Hardware Installation Guide
To connect the BSR to the backbone through a BSDU (Figure 6-14):
1.
2.
3.
Connect the 15-pin D-type male connector, at one end of the CAT 5 cable, to
the BSR’s 15-pin D-type port labeled DATA POWER SYNC.
Connect the 15-pin D-type male connector, at the other end of the CAT-5 cable,
to one of the six BSDU’s 15-pin D-type ports labeled BSR, located at the rear of
the BSDU.
Connect one of the BSDU’s 100Base-T ports, located at the front panel, to the
backbone (for a detailed description of connecting the BSDU to the backhaul,
see Chapter 5, “Installing the BSDU”).
Note: For a detailed description of cabling the BSDU to the backbone, see
Chapter 5, “Installing the BSDU””.
6-24 Airspan Networks Inc. 02030311-07