User's Manual

Mounting the Devices Hardware Installation Guide
13-6 Airspan Networks Inc. 02030311-07
5. Attach the SPR to the mounting bracket by performing the following:
a. Slide an M10 spring lock washer and then an M10 plain washer onto each
M10 hex head screw (ensure lock washer is nearest to head of screw bolt).
b. Align the mounting bracket's holes with the BSR's mounting holes as
displayed below. (The mounting bracket side that provides a groove for
inserting a nut must be aligned with the BSR's mounting hole that is nearest
to the BSR's rear panel.)
c. From the external sides, insert the M10 hex head screws through the
mounting bracket's holes and BSR's mounting holes. Loosely fasten with the
M10 hex nuts.
Figure 13-6: Attaching SPR to mounting bracket