User's Manual

Hardware Installation Guide Mounting the Devices

02030311-07 Airspan Networks Inc. 7-5

b. Choose an elevation hole on the mounting bracket and then align it with the

corresponding hole on the clamping bracket. Slide an M6 spring lock washer

onto an M6 hex head screw, and then from the external side of the mounting

bracket, insert the M6 hex head screw through the elevation hole on the

mounting bracket and into the clamping bracket's corresponding hole. Fasten

but not tightly the M6 hex head screw (the clamping bracket provides built-

in nut). The elevation hole can later be changed according to desired antenna

orientation in the elevation plane.

Figure 7-5: Clamping bracket attached to mounting bracket

3. Attach the U-bolt to the pole:

a. Place one U-bolt around the pole, and then insert the U-bolt screw side

through the two corresponding holes (horizontally parrallel) on the clamping

bracket. Slide an M8 flat washer and M8 spring lock washer onto each U-

bolt screw side (ensure that the flat washer is adjacent to the clamping

bracket). Fasten each U-bolt side with the two M8 hex nuts.

b. Attach the second U-bolt as described above.

Pivot hole

Clamping

racket

Selected

elevation hole