User's Manual

02030311-07 Airspan Networks Inc. 7-1

Mounting the Devices

This chapter describes the mounting procedures for the following devices:

 BSR

 BSDU

 SDA-1/48V

 BSPS

7.1. Pole-Mounting the BSR

The BSR is typically mounted on a pole, however, it can be wall mounted as well.

Pole mounting allows the BSR to be easily adjusted in the horizontal (azimuth) and

vertical (elevation) planes for antenna alignment.

Note: In the standard BSR kit, Airspan does not supply wall-mounting

brackets. To order wall-mounting brackets, contact your Airspan

representative. BSR wall mounting is identical to SPR wall mounting.

Therefore, for a detailed description of wall mounting, see SPR wall mounting

in Part II, Chapter 13, "Mounting the Devices".

The BSR is mounted using the mounting holes located on the BSR’s bottom panel

(see Figure 7-1) and the supplied pole-mounting brackets. The pole-mounting

bracket is designed to support the BSR on a round pole of 45 mm in diameter.