Installation Manual

Installing the BSR Hardware Installation Guide
6.4. Cabling for Serial Configuration
The BSR provides an RS-232 port for serial interface to a PC. This serial interface
allows you to perform local BSR configuration.
Notes:
1) For serial configuration, the BSR must remain connected to the BSDU/SDA
(i.e., the BSR’s 15-pin D-type port remains connected to the BSDU’s/SDA’s 15-
pin D-type port).
2) For a detailed explanation on performing BSR initial configuration, refer to
WipConfig User’s Guide or WipConfig PDA User’s Guide.
The following lists the BSR-to-PC serial cabling:





Cable: crossover serial cable
Connectors:
BSR side: 9-pin D-type male
PC side: 9-pin D-type female
Connector pinouts:
Table 6-2: BSR-to-PC serial connector pinouts
Crossover serial cable
BSR PC
9-pin D-type
male
Pin Function Pin Function 9-pin D-type
female
2 RS232 Rx 3 Tx
3 RS232 Tx 2 Rx
5 GND 5 GND
Note: Pins not mentioned are not connected
6-14 Airspan Networks Inc. 02030311-07