User Manual

Installing the BSR Hardware Installation Guide
The following lists the BSR-to-third party antenna cable setup:


Cable (third party): RF coaxial
Connector (third party): N-type male (two N-type connectors for BSR model
for 900 MHz band. The N-type socket labeled Primary is used only if one
antenna is connected. If you are using two antennas for diversity coverage,
attach the second antenna to the other N-type socket.)
Warnings:
1) Before connecting the external antenna, ensure that the BSR is NOT
connected to the power source.
2) Before powering on the BSR, ensure that some type of equipment such as
an antenna or an RF attenuator is connected to the N-type socket. This
eliminates the risk of damaging the BSR device.
6-12 Airspan Networks Inc. 02030311-07