User's Manual

AirHarmony-1000 Installation Guide
UGD-D01006 Airspan Commercial and Internal Use 39
6 Cable Connections
Hazardous voltage! Before working, ensure that the power is removed from the power
connection cables. When the system is powered on, do not touch the power
terminals.
6.1 Connecting the AC/DC Power Converter to
AirHarmony-1000
The DC Connector comes pre-assembled on the AC/DC Converter, as shown below:
Figure 32: AC/DC Converter with DC power connector
6.1.1 Power Cable Preparation
The Power cable is connected to the AirHarmony-1000 using a Gland connector assembled on the
bottom panel of the unit.
1. Remove the connector by unscrewing the body from the AirHarmony-1000, using the Gland
wrench.
2. Pass the pre-assembled connector through the tail nut, gland seal, body and rubber seal of
the connector casing as shown below. Do not tighten the tail nut.
Figure 33: DC Power connector pre-assembled on converter
Note The connector is attached inside the weather protected area of the enclosure and
is not subjected to water/moisture therefore the use of die-electric gels is not required.
3. Connect the DC power cable connector to the female connector outlet inside the unit.