User's Manual

AirHarmony-1000 Installation Guide
UGD-D01006 Airspan Commercial and Internal Use 17
3 Verifying Prerequisites
Prior to installing the AirHarmony-1000, verify the required safety, power, tools, parts and
components. This chapter includes the hardware, software, and client requirements for installation.
Important: Set up requirements for the installation is detailed in the Job Sheet, see Appendix A.
3.1 Verifying Site Requirements
To set up the AirHarmony-1000, an IP connection to a Netspan server is required.
3.2 Verify Installation Requirements
3.2.1 Verify the Tools
Note: AirHarmony-1000 variants with front mounted, Sunshield (pending) and Switched Beam
(pending) antennas come pre-assembled from the production line.
Table 7. Minimum Hardware Requirements
Tool
Use
Large flat bladed screwdriver
securing the pole straps
10mm or 13/32 inch wrench
for securing flange nuts
Large pliers
Tightening cable glands - To fit 15mm
3.2.2 Verify the Parts and Kits
Note: Verify order and requirements to ensure the correct unit type is being installed.
Table 8. Parts & Kits
Installation Kit / Part
Part No.
Consisting of:
Note:
AirHarmony 1000 2.5 GHz
(B38, B41), Conn
HAR10-CN-U41-
B01D
AirHarmony 1000 2.496 - 2.69
GHz (B38, B41),
Connectorized, Fiber BH
DC output - 16AWG x
4 connected to
AirHarmony 1000 DC
connector
AirHarmony 1000, 2.3 GHz
(B40), Front
HAR10-FM-U40-
B01D
AirHarmony 1000 Front Mount,
2.3 GHz (B40), Fiber
Backhaul, DC
DC output - 16AWG x
4 connected to
AirHarmony 1000 DC
connector
AirHarmony 1000, 2.3 GHz
(B40), Conn
HAR10-CN-U40-
B01D
AirHarmony 1000
Connectroized, 2.3 GHz (B40),
Fiber Backhaul, DC
DC output - 16AWG x
4 connected to
AirHarmony 1000 DC
connector
AirHarmony 1000 universal
wall & pole mounting kit
HAR10-U-PMK-1
Wall / pole mounting bracket
for the AirHarmony + 4 bands
GPS Antenna
GPS-ANT-3
GPS Antenna
GPS Kit
GPS-HAR-KIT-1
GPS antenna, bracket, 16m
cable and surge protection kit
For remote GPS
antenna installation