Installation Guide

AirHarmony‐4200DC(InternalFilters)InstallationGuide
UGD‐D01196 AirspanCommercialandInternalUse 42

Figure19:Glandconnector‐copper


1. RemovetheGlandconnectorbyunscrewingthebod yfromtheAirHarmony‐4200DC,
usingthe(supplied)Glandwrench.
2. PassthepreparedEthernetcablethroughthetailnut,glandseal,bodyandfrontsealof
theconnectorcasingasshownbelow.Donottightenthetailnut.

Figure20:EthernetCablethroughconnector


3. SeattheRJ45connectorplugsecurelyintothebodycavityoftheAirHarmony‐4200DC
4. TightentheGlandbodyintotothethreadedholeonthebottomoftheAirHarmony‐
4200DC.
5. TightenthetailnutontothebodyusingtheincludedGlandwrench,forcingthe
seal
compressaroundthecable.
6. Oncetheconnectorisproperlyinstalled,thecableshouldbepositionedandsecuredto
minimizestressonthecable.
5.4 Fiber Ethernet (SFP) Cable Installation
TheFiberEthernetSmallform‐factorpluggabletransceiver(SFP)mustbeconnectedtothe
AirHarmony‐4200DCusinganoutdoorfibercable.Theopticalconnectionenablesaone‐hand
installationoftheconnector.ThisenablestheuserstoeasilyremoveandreplacetheSFPtransceiver